It can be difficult to learn how to install Carpet or rug but this guide will show you how to install carpet or rug, tack strips, and carpet or rug padding and will show you how to lay carpet or rug. You can also order custom logo rugs for you firms or offices from any site such as ultimatemats.com.
Measurement the room
Divide the square footage by 9 to convert square feet into square yards. To ensure that you have enough carpet or rug to cover your floor. This will help will you how to lay carpet or rug in a square or rectangular room. Carpet or rug is measured in square yards.
Prepare the Subfloor
- Take out any carpet or ruging or flooring
- Vacuum the subfloor thoroughly.
- Baseboards can be reinstalled before or after you install the new carpet or rug depending on your preference.
- For mounting baseboard, check with your carpet or rug manufacturer.
Install the Carpet or rug Tack Strips
- You can use a handsaw or specialized snips to cut the carpet or rug tack strips to fit around the room’s perimeter.
- Between the walls and the tack strip, leave a distance of approximately two-thirds of the carpet or rug’s thickness between them.
- Tack strips should be installed so that they wrap around the door frames.
Carpet or rug padding should be installed
- Secure the carpet or rug pad to the edge of the tack strip with a staple gun-tacker
- Remove excess pad from the edge of your tack strip.
- Follow the manufacturer’s recommendations for carpet or rug adhesive when installing carpet or rug padding onto concrete. To cut the carpet or rug pad to the desired length, use a carpet or rug trimmer/sharp utility knife.
Measure and cut the carpet or rug
- Place a piece of plywood underneath the carpet or rug so that the chalk line is facing up.
- Use a utility knife to measure the back of your carpet or rug.
- With the backing facing inward, roll up the carpet or rug.
- It is important to measure your space accurately before you attempt to install carpet or rug yourself.
- Roll enough carpet or rug.
- Measure the length of the longest wall in the room.
Lay the Carpet or rug and Secure the Seams
- Check that the seams are tight throughout the length of the carpet or rug by lowering the raised section.
- To cover the floor, roll additional pieces of carpet or ruging.
- A minimum of 3 inches of additional carpet or rug should be kept near the wall.
- Follow the manufacturer’s instructions and place the heated seaming iron in the seam.
- Heat-activated seaming tape is used where two pieces are connected.
- Make sure that adjoining edges touch and are straight.
Anchor along the First Wall
- Once the carpet or rug has been attached to the first wall, trim any excess using a wall carpet or rug trimmer.
- Use a carpet or rug tucker to press the cut edge underneath the baseboard.
- Adjust the trimmer to match the carpet or rug’s thickness.
- A knee kicker should be placed 3 inches away from a long wall, near a corner.
Stretch the Carpet or rug
- Move the carpet or rug along the wall with the anchor, and then use a stretcher with lever action.
- To attach the carpet or rug to the tack strip, reach in front of the power stretcher.
- Continue stretching the carpet or rug along the wall in sections.
Install transition strips
- Finish your carpet or rug installation by placing carpet or rug transition strips where carpet or rug meets other types of flooring.
- To prevent carpet or rug from unravelling, seal the edges with latex seam sealing.
- To successfully install carpet or rug, you will need specialized tools.